0
Should be located in a removable housing at the engine end of the upper radiator hose Drain about 1 gallon of coolant from the radiator
Remove this housing
Note how thermostat is installed
Clean both surfaces
Install new thermostat and gasket
Reinstall housing
Re-fill coolant slowly to prevent an airlock
Start engine and look for leaks
Run engine to normal operating temperature with heater on
Re-check coolant level
Add your answer:
Earn +20 pts
Where is the thermostat located on a 1996 Chrysler Town and Country van?
It is under the housing where the upper radiator hose attaches to the block.
How do you activate valet mode on 1996 Chrysler Town and Country?
There is no valet mode on a 1996 Chrysler Town and Country.
How do you reset a kill switch on a 1996 Chrysler Town and Country?
A 1996 Chrysler Town and Country does not have a kill switch.
How do you bleed the injectors on a 1996 Chrysler Town and Country?
The fuel injectors are self bleeding on a 1996 Chrysler Town and Country.
How much does the thermostat in a 1996 Chrysler cirrus cost?
The actual parts cost about $4.00 to $8.00 but if you have a mechanic change it for you expect to pay around $70.00 in labor.
How do you reset your alarm system on a 1996 Chrysler town and country lxi?
how to reset the antitheft alarm system in a 1996 Chrysler town&country lxi
How do you change a thermostat in a 1996 jimmy?
kick it.
Where is oxygen sensor located on a 1996 Chrysler Town and Country?
A 1996 Chrysler Town and Country has two oxygen sensors. They are screwed into the exhaust on the rear of the engine.
Where are the oxygen sensors located in a 1996 Chrysler Town and Country?
The oxygen sensors on a 1996 Chrysler Town and Country are screwed into the exhaust system behind the engine.
Does a 1996 Chrysler town and country have a kill switch?
No.
Does a 1996 Chrysler town and country have inertia switch?
No, Chrysler does not use inertia switches.
Where is the odometer cable in a 1996 Chrysler town and country?
A 1996 Chrysler Town and Country does not have a speedometer or odometer cable. That signal comes from the transmission output speed sensor.
