You need a special tool called a Serpentine Belt Tool. In Sears it’s the KD Tools Geared Serpentine Belt Tool Sears item #00947098000 Mfr. model #3680. The key to replacing the belt is pulling down the tension wheel enough so that you can lift the belt around it. The problem with standard tools is that there’s no room to angle a conventional tool in. When assembled the belt tool forms an angle that is just right for the job. Also, when you’re ready to remount the belt feed the belt around all the wheels except the idler pulley. Pull down the tension wheel belt tool and slide the belt over the idler pulley and you’re done. Then keep the belt tool the back of your van because every time you hit a puddle you will have to do the whole thing over again. – Mike Snodderly, USAF retired
what do I need to change the 1997 Plymouth voyager transmission oil
I HAVE A SHOP MANUAL FOR A 1992 VOYAGER.....IF YOU NEED,,,,I CAN LOOK UP THE INFO YOU NEED.....JTUPKO@SNET.NET
www.autozone.com look for specs and or parts location
The Plymouth Grand Voyager.
Depends on what size engine it is on...
lacing windshield fluid reseroir on 198 plymouth grand voyager
there should be an automatic tentioner on the serp. if not look at the alt it will have slotted holes to loosen up
check to see if there was a recall. I have a 1996 Plymouth grand voyager and the garage replaced mine free of charge.
The 1987 Plymouth Voyager weighs in at about 3,305 pounds. The 1987 Plymouth Grand Voyager weighs right around 3,531 pounds.
It doesn't, a 1996 Plymouth Voyager does not have a cabin filter.
The panel is broken. Replace it
The 1987 Plymouth Voyager weighs in at about 3,305 pounds. The 1987 Plymouth Grand Voyager weighs right around 3,531 pounds.