0
Add your answer:
Earn +20 pts
How do you change an oxygen sensor in a 2002 Pontiac Grand Am?
Please answer the question. "How do you change an oxygen sensor in a 2002 Pontiac Bonneville
Where is the crank sensor on a 1989 Pontiac sunbird 2.0?
Crank sensors are always located on the camshafts. The 1989 Pontiac Sunbird crank sensor is located on the head of the engine towards to end of the camshaft.
Why does a 1993 Pontiac sunbird stall when you stop?
one of the map sensor or vacuum switch.
Where is the oil sensor located for the 1989 Pontiac Sunbird?
right above the oil filter
Where is the location of the oil sensor in a '90 Pontiac Sunbird?
beside coil pack behind firewall
Where is the mass air flow sensor on a '94 sunbird?
The mass air flow sensor on a 1994 Pontiac Sunbird can be found between the throttle body and the air box duct. Some of the items needs to change the sensor are straight edge screwdriver, shop vac, and T-20 security bit driver.
How do to install oxygen sensor on 2006 Pontiac torrent?
We are asking how to remove and install a oxygen sensor for a2006 pontiac torrent.
On a 1994 Pontiac Sunbird 3.1 where is the camshaft sensor?
There is no cam sensor on this particular engine. Only a crank sensor mounted behind the harmonic balancer.
Why does the fan come on when the car is first started on a 1990 Pontiac Sunbird the temp sensor has been changed?
the fan relay sensor is out of it.
Where is the crank sensor located on 1990 Pontiac Sunbird?
I have a 1992 Pontiac Sunbird with 2.0 four cylinder in it, just found the crank sensor on it, to replace it. It is located on the FRONT side of the engine, below exhaust manifold and just above the A/C compressor. HOPE THIS HELPS SOMEONE ELSE!
Why does 1990 Pontiac Sunbird idles rough after tuneup?
Did they replace the MAP sensor? If not, good chance there's your problem.
1989 Pontiac sunbird ideling up and down?
It could be the oxygen sensor, or the carburetor/throttle body/ fuel injectors whichever your car has may be dirty. You might need to change the spark plugs, wires and cap and rotor etc. More information would be helpful.
