Depending on the year and model/trim of your car, there are two possibilities here.
If the information console (the overhead console in which the map light is located) does NOT have a built-in garage door opener, then you can simply grab the front end of the console, and pull down. This will remove the console, and expose the light bulbs which can easily be replaced.
If the console DOES have a built-in garage door opener, then you must locate a small screw that is towards the windshield. Use a Phillips head screwdriver to remove the screw, and then pull off the faceplate to expose the bulbs.
Whatever you do, NEVER use a flat head screwdriver to pry the console off. Use your hands only. Using screwdrivers just gouges the plastic or tears the head-liner on your car, and makes it look like a botched job.
This is the correct protocal for a 2000 300M.
Carefully remove the lens then bulb
light bulb out on map light how to change with out breaking plastic lens
You can replace the map light bald, on your Chrysler 300, by removing the decorative retaining nut. The lens will come off with the nut, exposing the light bulb.
The map light on a 2004 Dodge Grand Caravan SXT is changed gently prying the edge of the cover to reveal the bulb. The bulb can then be popped out and a new bulb installed.
how to replace map light bulb in a 2006 pontiac torrent
Just pop off the plastic lens... easiest if you pry from the middle.
To replace a light bulb in the map light on a 1996 Toyota Camry, the lens for the light has to be removed. There are clips at two opposite ends that have to be nudged gently with a flat screwdriver to get the lens cover off.
Remove the map light retaining ring. Remove the map light cover. Take hold of the lightbulb, push in and turn at the same time. The lightbulb will come out.
It doesn't have a dome light... it's a map light, #105
Just take the cover off and plug in the new bulb.
change MAP sensor
how do i change the bulb in the clock on 2004 lincoln town car