this is for a 2002 doge durango, it must be the same
LOCK CYLINDER
REMOVAL
The ignition key must be in the key cylinder for cylinder removal.
# Disconnect negative cable from battery. # Remove upper and lower covers (shrouds) from steering column. # Place shifter in PARK position.
# A retaining pin (Fig. 9) is located at side of key cylinder assembly. # Rotate key to RUN position. # Press in on retaining pin while pulling key cylinder from ignition switch.
INSTALLATION
The ignition key must be in the key cylinder for cylinder installation.
# Install the key cylinder into the housing using care to align the end of the key cylinder with the ignition switch. # Push the key cylinder in until it clicks. # Replace the upper and lower shrouds. # Reconnect the battery.
You will have to destroy the old one to remove, possible by drilling straight through it.
how do i change to front brakes on a dodge durango?
Remove the covers to the steering column, then use a small screw driver and push in tab on bottom of cylinder with key in run position and pull out.
How do you change shift cylinoid on 1998 dodge Durango
No, the V6 and V8 transmissions are different.
krysta krysta
Cylinder number eight is the rear passenger side cylinder.
Cylinder #7 Misfire
In the firewall behind the master cylinder.
the ignition coil
What size wrench do you need to change the front brakes on a 2001 dodge durango?"
Yes, buy the Haynes Repair Manual.