Remove the dog-house, drill out the rivets holding the original ignition coil, replace coil using bolts or new rivets.
Before changing I would test it, not a common failed part. Though the distributor gear is a very common wear item on these vans, I would check that. Also might be cheaper to replace the distributor instead of just the gear.
hope this helps.
On top of the RH Side of the Engine. You will need to remove the engine cover from the inside of the van to get to it. Just trace the coil wire from the distributor.
pull the dash and geta haynes tech bookand follow it carefully
Right under the ignition cap.
n ignition switch on a 1991 Chevrolet astro vanAnswern ignition switch on a 1991 Chevrolet astro van
The 1994 Astro Van fusible ignition links can be found in the fuse box. The fuse box can be found in the engine compartment, on the drivers side.
You will need to remove the ignition switch retaining ring in your 2002 Chevy Astro Van. Slide the ignition switch out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install the new ignition switch.
yes, they are in the distributor. Take the cap off, remove the rotor and there it is. The problem could be a bad coil
You can remove the 2000 Chevrolet Astro Van the ignition switch cylinder by removing the retaining ring. The retaining ring will need to be turned to the left. The ignition switch cylinder will slide out.
well it is the bottom that goes on a ignition coil and it is locoed
One to repair an ignition switch on your Astro Van is buy a replacement steering column from a local salvage yard including the ignition key, and replace the whole steering column. RC Houston, TX
The coil is mounted on the intake manifold on the passengers side. It is closer to the front of the engine and quite difficult to get at, I had to take the doghouse off to get at it but it can be done. When in doubt follow the lead wire off of the distributor.