The majority of these motors are held in with large rivits that have to be drilled out, then either put back in with rivits or small bolts and nuts but it sometimes is hard to get behind the motor and bracket to hold the nut, I`ve welded the nuts on the back of the unit. to get to the motor you have to take the door panel off it could be held on a bunch of different ways, screws hedden behind plastic covers or they might be out in the open, or going through the door pull. Then there is usually some plastic "clips" that go around the primiter of the door. they will pop out,there is a special tool made for these but if you use a putty knife and carefully pry next to them you might be able to gradualy work them out, ther will be several of these depending how large the door. Be carful not to on pull electic wires as you take the panel off, you may have to unplug some. Everything I have written here applies to most door panels and widow motors It may not apply to all but most Iv`e worked on! Good Luck. Mark, 12/23/05
To change the motor in the 1996 Chevy Cavalier driver's side window, first pry the interior door panel from the door. Then, remove the motor by first disconnecting the vehicle's battery and then disconnecting the wiring to the motor. You can then remove the screws that hold the motor in place.
I have a 1990 Pontiac Transport SE, I have the changed the motor on the driver's window which is power...take off the door panel and you will see the motor...not too difficult of a job...follow the old motor route...
I would try the window switch first , but if you are going to replace the switch then you will see how to replace the motor. You would have to take the door panel apart after that its easy.
Replacing 2002 Dodge power window motor driver side
in the door
I need instructions on how to change the window motor in 1995 Chevy Camaro.
pls see... http://www.faqfarm.com/Q/What_is_wrong_when_the_front_passenger_power_window_motor_sounds_like_it%27s_going_to_work_but_then_stops_and_the_window_will_not_move_on_a_1999_Jeep_Grand_Cherokee
change the window motor as it's getting hot and shutting down.
Pull off door panel. Roll window half way down. Un-bolt window. There should be four bolts on the door panel that hold the motor. Take the arm off the left on driver side or right on passenger. Then motor should just slide out of the hole.
how to replace window motor ion 91 madza miata
How do you remove and replace the motor for the drivers side power window in a 2000 Sienna
if manual, window regulator. if electric, check fuses, window switch, window motor, window regulator.