first of all you'll need 2 people a crow bar,rachet set and a wrench. well you'll need to take a crow bar and put it in between the tensor pulley to get the pressure off the belt and take that off, then just take the 3 or so bolts and wires off the back and replace with a new one. just make sure to get your wires back where and how they were. then to get the belt back on your going to have to have your other person put the belt on while you are getting the tensor and its ussually a tuff one.
The MAP Sensor on the GMC Sonoma is located in the engine compartment just to the left of the alternator. The MAP Sensor is usually colored silver or shows a gold tint.
In your garage or driveway!
right under the almost impossible to get to alternator......
Take the whole lens out
No, a 95 GMC Sonoma does not use a timing belt on it. The 95 GMC Sonoma uses a timing chain on it.
The GMC S-15 became the GMC Sonoma in 1991.
To change a fuel vapor sensor on a 1997 GMC Sonoma you need to disconnect the wires that are holding it in place. Next, remove the old sensor and replace with the new one.
Are you sure your vehicle has one?
Where is the timing connector on a 1995 gmc sonoma
will the 2.2 crossmember on a 1994 GMC sonoma fit on a 1994 GMC sonoma 3.4
were is csp on gmc sonoma 2.2
How do you flush the raditor on a 1992 GMC Sonoma Pickup.