answersLogoWhite

0


Best Answer

you have to use a press to pop out the ball joint, you might consider removing your a arm and bring it to a shop with press so that you can have your new ball bearing pressed

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change lower ball joint on 1996 gmc sonoma?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change a ball joint for a 1996 Elantra?

You need to actually buy a complete lower control arm. The BJ isn't removable. A few tools and about an hour to change in your driveway. Need more help let me know


Where is the lower ball joint on a 96 Ford Explorer?

On a 1996 Ford Explorer : There are ( 2 ) lower ball joints on the front suspension . Each lower control arm , drivers side and passenger side has ( 1 ) ball joint


How to remove a starter from 1996 GMC Sonoma?

i have a 91 sonoma. For advice it was easiest to unbolt the the flywheel/flexplate cover. this allows you to wiggle the starter towards the front of the truck and then lower it down. ( you do not need to remove the cover; just move it out of the way.


How do you change a velocity joint in a 1996 Chevy Corsica?

To change a velocity joint in a 1996 Chevy Corsica, you will need to first lift the vehicle and remove the wheel. Then, disconnect the drive shaft from the transmission and remove the old velocity joint. Install the new velocity joint, reconnect the drive shaft, and put the wheel back on before lowering the vehicle.


How hard would it be to replace oil pan on 1995 Sonoma?

How hard would it be to replace oil pan on 1996 Sonoma?


What causes a 1996 gmc sonoma to start skipping real bad after you change it into 3rd gear?

check your distributor some of your cylinders are not firing or just get a new truck


How do you replace lower ball joint on 1996 Honda civic?

Not so easy.This is pressed into the lower control arm.So :Jack and support carRemove lower ball joint to upright nut.Separate ball joint from upright. Usually with a hammer and suspension fork.In some cases there is a spot weld that needs to be ground off in place of the snap ring.Remove the snap ring that retains the joint into the lower control arm.Use your portable ball joint and suspension press to remove and install the replacement joint.Assembly is reverse of disassembly.


How do you change dimmer switch in a 1996 cadillac deville?

Its on the lower part of the steering column where can I get a diagram showing where it is and how to change it?


Where are the freeze plugs in a 1996 gmc sonoma?

Where are the freeze plugs located on a 2003 GMC Sonoma 4.3L Vortec engine?


What are the release dates for Joint Adventure - 1996?

Joint Adventure - 1996 was released on: USA: 1996 (Hamptons International Film Festival)


Is a 1996 Chevy 1500 transmission compatible with a 1994 GMC Sonoma?

NO. They are different.


How do you change the ball joints on a 1996 Mercury Mystique?

You will need to remove the tire and wheel. Remove the nut from the top of the ball joint. Pound the ball joint out with a hammer. Reverse the process to install the new ball joint.