You will need to open the hood, and then using a pair of pliers, remove the headlight housing retaining clips. Pull upwards on the clips to remove them from the housing.
Once complete, you will be able to pull the headlight housing out & away from the vehicle to unplug the connectors, and remove the holder and bulb.
Ford Freestar was created in 2004.
It will hold 5 quarts exactly with a filter change.
( 26 U.S. gallons ) for a 2004 Ford Freestar
One reason a 2004 Ford Freestar may stall out is because of a water damaged PCM. This is a common problem with the 2004 Ford Freestar.
According to the 2004 Ford Freestar Owner Guide : ( 26.0 U.S. gallons )
how can ford freestar 2004 water pump be replaced
On a 2004 Ford Freestar : The transaxle ( transmission ) is located in the engine compartment on the drivers side . It is bolted to the " rear " of the engine
there is no coil on 2004 freestar 3.9L engine. it is only an ignition module and it is located in the back of the engine by the firewall.
take out the light bulb
I need to change the rear driver side tail signal . I do not know how to get at the bulbs . Do I have to take the whole inside panel off?
I change my belt at approx 80,000 km or 50,000 miles, or when the belt as cracks orcuts.The above sounds like a serpentine belt...The Freestar/Monterey/Windstars do not have a timing belt - they are equipped with a timing chain which does not require routine replacement.
According to the 2004 Ford Freestar Owner Guide : For both the 3.9 liter V6 and the 4.2 liter V6: With engine oil filter change : ( 5.0 U.S. quarts of 5W-20 engine oil )