I'm not sure what you are asking... If your turn signals are not working for either direction, your "flasher unit" is probably the problem. (really cheap and easy to replace) If one signal is working and the other is not, then one of the bulbs are burnt out.
If I am not understanding your actual question... I'm sorry.
If its a Olds Cutlass Supreme, its a fairly easy process. Grab the turn signal stalk firmly near its base. Gently wiggle, and slightly twist while pulling it out. Replace with the new stank and plug in the small plug at the base of the stalk. And your done If you are talking about a Olds Cutlass Ciera, its not a easy process, and I pay to get it done.
Very likely it's the turn signal switch.
I HAVE A 1992 OLDS CUTLASS SUPREME JUST BE FOR it warm up it cuts off
i had same problem on my 94 cutlass supreme...long story short, it was the ignition switch. $300. at shop.
Remove steering wheel (with wheel puller), remove lockplate (with lockplate remover), remove 3 screws that hold turn signal switch, unplug switch at bottom of column, fish out the wires, install new switch, fish in new wires.
The oil pressure switch on a 1995 cutlass supreme is located under the hood front center of the oil pan. It is right beside the oil filter.?æ
The 1994 Oldsmobile Cutlass turn signal relay switch can be found below the dashboard. The relay switch will be on the drivers side of the passenger compartment.
rightside bottom of steering column
i need to replace the ecm on a 1993 olds cutlass supreme,can i replace it with another ecm from another olds cutlass?
its in the steering colume replace the turn signal switch
With the lights on pull on the turn signal lever. High beams should come on. Pull again and they should go off.
It is built into the headlight switch.