0
Crankshaft Sensor is located at back of engine near the flywheel. Two bolts hold it on and there is a connector with two wires. CPS cost approx. $30. Screw out 2 bolts, undo connector and pull out of engine block. Their may also be a dust cover and shims. Enjoy.
Add your answer:
Earn +20 pts
There is no spark on a jeep 1988?
Probably a crank sensor
Does a 1988 Ford Mustang have a crank shaft position sensor?
I think you mean CAMSHAFT position sensor.
1988 Chevrolet 1500 350 cranck shaft poitioner sensor?
Gm. did not use a crank shaft sensor in 1988, It had a distributor that done everything.
What would cause a 1988 Buick lasabre to not have spark?
A faulty crank sensor can do that.
Where is the crank sensor location on a 1986 Camaro z28?
There is no crank sensor on a 1986 camaro z28.. that sensor is in the camaros past 1988 i believe.. but the 1986 carb or fuel injection (tpi) does not have one
Where is the crank position sensor on a 1988 Cavalier?
check on the back of the motor above the transmission
Why does your 1988 Buick Regal not start when you try to crank it after it has been running?
if it has a crankshaft sensor that's bad
How do you know when a crank sensor is bad in a 1988 Mazda 626 and how do you replace it?
Generally when the crank sensor goes out the engine will not start. The sensor on almost all vehicles is located in the front on the engine near the belts.In most cases it is held in place by a bolt.Usually they can be hard to get to.
Where is a camshaft position senson on 1988 Pontiac Bonneville?
The Camshaft Sensor is located right behind the crank shaft fly wheel and can be very hard to change out without consulting a mechanic first.
Where can you find the crank sensor on a 1988 Chevy Celebrity Wagon?
it will be mounted at the harmonic balancer on the bottom and front of the engine
Is there a kill switch on the fly wheel of a 1988 Jeep Commanche?
I don't know of a kill switch but there is a crank sensor.
Does a 1988 Oldsmobile calais have a crank sensor or ignition module?
yes the 2.5L 4 cyl engine has the ignition module mounted to the back of the engine block,firewall side.the crank sensor is also there under the moduel and coils
