it is located behind the Power Steering pump. You need to remove the power steering pump and the rest is self explanatory.
Camshaft position is taken from the distributor, there is no separate sensor.
change camshaft sensor,it is under power steering pump. remove pump, but do not remove any hoses. set pump aside and sensor is reachable. take out bolt holding sensor then pull sensor out of engine.
The camshaft position sensor on a Mazda Miata is changed by disconnecting the wiring harness and unscrewing the sensor using a wrench. The threads can then be cleaned and a new sensor torqued into place.
take the belt off, remove the three bolts by turning the pulley (there are three holes in it to see the bolts), then you can get to the camshaft sensor.
Where is the camshaft position sensor on a 2005 Expedition?
The 1995 for Crown Victoria camshaft position sensor can be found on the back of the cylinder head. The camshaft position sensor will be labeled as such.
location of the camshaft sensor
if you do it yourself,you only pay for sensor!! to change sensor on a v6, remove power steering pump and set aside do not remove hoses,sensor is under pump!! remove hold down bolt then wiggle it out!!
Camshaft position actuator A bank 2 usually means change the camshaft position sensor
Do you have a video of the hhr camshaft position sensor
i have been told my camshaft position sensor needs changing on my Renault scenic 2005 model a have brought one but don't know where it is to change it
There isn't a camshaft position sensor. If you are asking because of an error code you received, it is caused by a signal that mimics the same signal as a camshaft position sensor.