answersLogoWhite

0


Best Answer

IF YOU HAVE A FACTORY RADIO WITH A SECURITY CODE write the code down before proceeding!!!!

If replacing the battery put the new battery on charge before you start to top it up if possible.

The Chevy Lumina battery is on the drivers side of the engine compartment. It is hidden under the windshield washer fluid tank and crossmember. The crossmember runs from the drivers side shock tower diagonally to the upper, front radiator support. Using a 9/16" socket remove the crossmember and set aside. Lift and set aside the relay panel, it should be a slide fit. Remove the washer fluid tank by pulling the 2 plastic fasteners on the front fingers of the tank straight up and off. Remove the rear bolt on the same tank (if fitted) lift the tank out and remove the hose attached to the pump, also remove the 12V power connector from the pump. Now you must remove the air cleaner by loosening the hose clamp holding it to the MAF unit. Between the filter housing and the battery shield loosen and remove the bolt. Remove the two bolts on the battery shield and lift off. Remove the negative battery connection FIRST. Then remove the positive cable connection. Lift the battery out and place aside. Clean the battery area with baking soda and warm water. Let dry and coat the battery pan with acid resisting paint (I use car body rubberized undercoat) Let dry thoroughly. Place the battery into the pan, now replace the positive cable, then the negative cable. Now install the battery cover, air filter and washer tank. Don't overtighten the clamps or bolts. Replace the relay box on it's mount and finally the crossmember. Good luck.

Andromeda451

Change the 9/16" socket to a 13mm if you don't want to risk rounding off the bolt. Also when removing the two plastic fasteners at the front of the windshield washer fluid tank pry with a screwdriver with one hand and cover it with the other hand or they may launch into orbit like one of mine did never to be found again

User Avatar

Wiki User

βˆ™ 13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change a battery in a 98 Chevy Lumina?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you reset the computer in a 98 Chevy Lumina?

i think you disconck the ground cable from the battery for at least 30 seconds


Oxygen sensor on a 98 Chevy Lumina?

On the muffler


Where are the battery terminals for jump starting a 1998 Chevy Lumina?

GM vehicles use side post batteries. The terminals are on the side of the battery. 98 Lumina with 3.8 it's on the drivers side under a red plastic cap for positive.


Is a 98 Chevy lumina a high mileage car?

Consider this - I have a 91' Chevy lumina with 256k miles on it, and aside from an oil leak, it still runs like a top


Where is power steering fluid in 98 Chevy lumina?

It is below the alternator and kind of hard to see.


Do both cooling fans on a Chevy lumina 98 run at the same time?

Only when the AC is on.


Volts light came on in 98 Chevy lumina car wont drive what does this mean?

Alternator is not charging battery sufficiently check with voltmeter With engine running voltmeter should read 13.8-14.2


Can you exchange a 1996 motor to a 1999 motor for a Chevy Lumina 3.1 engine without it giving you electrical problems Will they be Interchangable?

what is the spark plug gap for a 98 Chevy lumina sedan 3.1Liter engine


Where is the turn signal flasher relay on a 1998 Chevy Lumina?

The Flasher Relay for the 98 Lumina Sedan, (and all 97-03 GM W-Body


How do you change a distributor on a 98 Chevy Silverado?

how to repace the distributor on an 98 chevy silverado


How do you remove the ignition switch on your 98' Chevy lumina ltz car?

You will need to remove the retaining ring at the top of your 1998 Chevy Lumina ignition switch. Slide the ignition switch out. Remove the wiring harness.


How do you disable a 98 Chevy lumina's factory alarm?

The easiest way to disable the 1998 Chevy Lumina factory alarm is to remove the factory alarm fuse. The factory alarm fuse can be found in the fuse box.