On the firewall, engine side, will be 2 hoses held onto the heater core pipes with clamps. Make sure the engine is cool, and get a bypass peice from your local Autozone, or what have you. Unscrew those clamps, and take the hoses off, then put the 2 hoses on the bypass pipe, and clamp back down. Do this only when the engine is cold. You will likely have to have the car up on jackstands, or wheel ramps. Its much easier to access the pipes from under the car. If you are tackling this job, you might just consider replacing the heater core while you are there. Its only about 30 mins more work, and is fairly easy. Best to grab a service manual for detailed instructions on this.
Drain the water from your 1994 Chevrolet Cavalier cooling system. Remove the water supply hoses from the heater core. Remove the heater core retaining bolts. Reverse the process to install your new heater core.
Just un hook the hose's from heater core and put a piece of pipe in them or something and hook them together.
Follow the heater hoses to the firewall. There should be 2. disconect them from the heater core, then insert a 5/8 hose bib and clamp them together.
No , if you were to bypass the heater core , you would have no heat
Take both heater hoses off at the heater and the hose running from the front, attach it to the rear of the engine.
Find the two hoses that go to the heater core, usually 3/4 in. hoses, and connect them. It's very simple.
join the inlet and outlet hoses together.
Detach the screw that attaches the heater duct on a Chevy Cavalier and remove the heater core. Once this is done you can replace the faulty heater core with a functional one.
you would have to bypass the heater core first.
Either the linkage from the temp control unit to the valve on the heater core (which is behind the radio and temp controls) or it is the heater core itself.
Heater coolant bypass pipe It would be the return hose for the heater.
The water from your 1989 Chevrolet Cavalier cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.