answersLogoWhite

0


Best Answer

As you did not include engine or Year info I will give a general answer.

Look on the top of the engine, most GM products with a bleed system have a small brass pipe thread plug in the top of a black or aluminum casting.

This is the bleed point, loosen the plug or valve and add coolant to the system until it flows from the bleed, tighten up the bleed. Done.

Repeat if needed.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you bleed my coolant system?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you bleed air out of coolant system 97 Saturn?

procedure on how to bleed air out of coolant system on 97 saturn ls


How do you bleed your V6 coolant system?

how do i bleed my accord v6 2000 coolant system, its has air and the rev's gone up & down......


Where is the place you bleed coolant system?

It is not necessary to bleed the coolant system. If you mean "drain" the system, there is usually a plastic plug on the radiator or, you can pull the lower radiator hose off.


How Do you Bleed The Coolant System On A 1998 Beetle?

To bleed the coolant system on a 1998 VW Beetle, remove the top from the overflow tank. Run the car for 10 to 15 minutes to force any air out of the system, then check the coolant level. Add coolant as needed.


How do you bleed the coolant system on a 2002 impala?

There is a bleed screw on the thermostat housing. Remove the screw with the engine loose. Ounc you have pure coolant and no air you can close off the bleed screw.


How do you Bleed the coolant system on a 2002 Chevrolet Impala?

There is a bleed screw on the thermostat housing. Remove the screw with the engine loose. Ounc you have pure coolant and no air you can close off the bleed screw.


How Do you Bleed The Coolant System On A 1998 2.0 Beetle?

Start by taking the top off of the coolant overflow reservoir. To bleed the system, run the 1998 VW 2.0 Beetle about 10 minutes, then check the coolant level. Add coolant if needed, then replace the reservoir top.


How do you bleed the coolant system on a 1999 mercury villager?

Not necessary on this vehicle.


How do you bleed coolant system after replacing thermostat?

what is the year make & modle of it??


How to bleed air from coolant system in a 3.5 Olds Aurora?

Good luck haha..


Bleed 3800 engine cooling system?

Is the question how to bleed a Buick 3800 cooling system? I would say open that little petcock by the themostat housing and release all the air as you fill the system with coolant. When coolant comes out instead of air all the air is out.


How do you bleed air out of a 1995 Intrepid 3.3 liter engine coolant system?

To bleed the coolant in a 1995 Dodge intrepid locate the drain plug on the underside of the radiator, un plug it and pour new coolant in the system. Close the plug and while the engine is running find the coolant pressure valve and loosen it to relieve pressure. When bubbles stop forming there is no longer air in the system.