0
Underneath your vehicle, a steel threaded cable comes from the back of one hub and is joined by a short cable from the other hub--then the original cable runs to a threaded end with an adjuster nut in it--and one smaller nut on the end outside of that--(this is the equalizer bar)--you'll see it real close to your transmission. You might have to jack-up the back of the vehicle??? Pull the parking brake lever up sharply and then release it. Pull the parking brake lever to the second click and leave it there. You're looking for a slight drag of the brake shoes when you spin the wheels. To increase the drag, get under at the equalizer bar and turn the adjusting nut to take up the slack in the cables. Get out and spin the rear wheels if you think it's to tight. I will say don't be afraid to crank on it for a while as in this case, a little adjustment really does not go a long way. When you think you have the drag right, go back in the car and pull the brake up the the fourth click. At this point the wheels should be locked and you should not be able to turn them even when trying hard. If you can, tighten them up a little more. Once you've done this, release the brake and make sure the wheels spin freely. If they are still binding due to the parking brake, back off the adjustment a little. And that's basically the whole adjustment procedure.
Add your answer:
Earn +20 pts
Are 1991 Cadillac Eldorados all wheel drive?
No
Where is the parking brake release on a 1991 cadillac sls?
the manual release lever is attached to the parking brake pedal assy
How do yopu adjust the parking brake on a 1991 toyato pickup?
Underneath the truck on the passengerside you will find the cable. if your not sure have someone pull brake while your under truck. The cable goes into a yoke, you simply turn it & cable wil cinch tighter,it may have a lock washer, that you loosen first. For your model its right when you get 7-12 clicks of your parking brake. Most cars design of the parking brake cable, & its adjustment, are the same.
Why does the brake light stay on in your 1991 mercury tracer?
Check the brake fluid level in your brake master cylinder in the engine compartment ( the brake light also comes on if the parking / emergency brake is applied )
Your motor turn over but it wont start up on your 1991 buick park ave?
Do you have your parking brake on?
Why would a 1991 Mazda miata emergency break quit working?
Rear calipers may need adjustment (they adjust differently than most cars with a rear disc parking brake) or replacement. Take it to a Miata specialist. And it's "brake" not "break". But really, if it doesnt work at all and it were your calipers, they would be screwed, otherwise it probably needs adjusted with theres an adjustment screw on the inner side of the parking brake lever.
What does brake warning light mean on 1991 Toyota Camry?
it means one or more of the following, the brake fluid is low, the parking brake lever is either up or the circuit for the paking brake switch is shorted, or if the battery light is also on, the car needs a new alternator.
How do you tighten the parking brake on a 1991 Geo Tracker?
Make sure service brakes are adjusted properly Emergency brake adjuster should either be under vehicle at junction of cables or at the side of the handle between the seats (May have to remove plastic trim) Set parking brake at 3 clicks-wheels should be held firm at this point
How do you adjust the emergency brake tension 1991 Geo Tracker?
Assuming all Trackers have a "Pull-Up" parking / Emergency brake between the seats like my '91 and '95 4WD's have: Remove the (4) screws holding the center housing / console to the floor and pull it up and forward over the brake handle (release the brake first!). This reveals the adjuster nut that's below the parking brake handle - the threaded rod the nut is on points toward the dash... simply use a wrench (10mm? can't recall) to turn the nut clockwise to pull more of the cable into the cab. DO NOT OVERTIGHTEN or you will burn up your rear brakes. Always err on the side of slack.
Why are Tail lights on with out pushing pedal on 1991 Nissan 240 sx?
brake paddle isn't pressing down the botton that switches off the brake light . you may have to adjust the brake paddle's distance to allow it to press and hold down that botton.
What would cause one wheel rim to get hot on a 1991 Buick Century?
Either brakes or bearings. The brake caliber may be sticking, parking brake mis-adjusted, if on the rear, or you are driving with your foot on the brake. Also a bad wheel bearing will get extremely hot.
Why does 1991 buick park ave gearshift stick in park position?
1st - I would Ask Myself am i parking on a Incline..??? Am I pressing the Brake Pedal Before Shifting into Gear..??? Check Your Brake / Transmission Shift Interlock Setting..!!!
