answersLogoWhite

0


Best Answer

There are three black knobs on each of the headlight housings. Next to the knobs are metal screws with a torx end on them. For each side, There is 1 knob and torx screw on top, 1 knob and torx screw near the fender and the last is underneath near the front bumper cover. The top knob and bottom knobs have to be loosened before you can adjust the headlight(s), (The bottom screw anchors the headlight in the mounting bracket). The torx screw on the top is turned clockwise to raise the headlight projection. To lower, counterclockwise. The set next to the fender moves the headlight left (counterclockwise) or right (clockwise). When you are done adjusting. Re-tighten the black knobs. A little WD-40 sprayed on the knobs and torx screws helps, prior to starting this project.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you adjust the headlights on a 1995 Monte Carlo?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you access the fuel pump on 1995 Monte Carlo?

how do you access the fuel pump on 1995 monte carlo?


What is the weight of a 1995 Chevrolet Monte Carlo?

The weight of a 1995 Chevrolet Monte Carlo is 1486(kg) or about 3276 pounds.


How do you unlock a 1995 Chevy Monte Carlo without a key?

i lost my key to unlock my Monte Carlo. how can i unlock it? it a 1995


Will a transmission from a 1995 Monte Carlo z34 fit on a 1996 Monte Carlo z34?

yup


Did Chevrolet make a 1992 Monte Carlo?

Monte Carlo was produced from 1970-1988 and then again from 1995-2007


Where is the fuse box on a 1995 Monte Carlo?

The fuse box on a 1995 Monte Carlo LS is on the passenger side as you open the door look on the side of the dash


Can a replacement hood from a 1995 Monte Carlo fit a 1999 Monte Carlo?

Yes, there is virtually no difference in the dimensions and installation hardware of body parts between 1995-1999 Chevy Monte Carlos.


How do you adjust the valves on a 1995 Chevy Monte Carlo 3.1 engine?

you cant if rattling noise occures its a worn lifter very common on 3.1 motors


Where is the crank position sensor on a 1995 Monte Carlo located?

The crankshaft position sensor for the 1995 Monte Carlo is located on the front of the engine. It is just to the right of where the crankshaft comes out of the engine.


How do you adjust headlights on a Nissan pickup?

how to adjust headlite on 1995 nissian pickup


How much does a 2003 Chevy Monte Carlo weigh?

The Chevrolet Monte Carlo LS coupe has a curb weight of 3,340 pounds. General Motors produced the Monte Carlo from 1970-1988 and again from 1995-2007.


Where was the 87 Monte Carlo first produced?

The Monte Carlo was a two door coupe made by Chevrolet from 1970 to 1988, and again from 1995 to 2007. From 1981 to 1988 the Monte Carlo was assembled in Arlington, Texas and in Pontiac, Michigan.