Underneath the 1995 Chevy 1500, the cables from the real wheels connect to the cable from the brake pedal. The connection has an adjustment bolt that when tightened will make the brakes tighter.
You may have to loosen the parking brake shoe adjuster.
If the parking brake pedal on your 2001 Dodge Ram 1500 is stuck to the floor, you might have broken the parking brake cable. Remove the rear tires to see if the cable is still attached and replace it as needed.
T-55
There are no ajustments for the hinges they are welded. NEUTZ
parking brake, push it down a touch
I installed a new e.brake shoes on a 2000 Chevy silverado 1500 4x4. Now I don't know how to adjust the cables so the brake works. How or where is the adjustment on the cables? If it's like my 2003 the adjustment is inside the hub. There's an adjustment wheel just like the old fashion star adjustment on drum brakes. I don't know if they are the same though?
It's usually just two screws, under the dash, just above the brake pedal. Remove the switch and plug the electrical connectors in to the new switch then adjust the new switch so that it comes on when the pedal is pressed.
Move the switch until it opens the contact when the brake pedal is pushed down 1/2".
the clutch system is self adjusting no adjustment can be made . check the clutch master cylinder reservior
Not all 1500's where built with it. If it is there it will be above the parking brake.
on the side of the brake assembly is a lever with a "u" at the bottom pull or pry it rearward-this will release the pedal (BE CAREFUL IT WILL RELEASE HARD)
Yes, you can adjust the brakes on the back side of the backing plate. There is a small rectangular hole near the bottom. Remove the rubber plug and use a brake shoe adjustment tool to adjust the brake shoes in or out.