Linkage adjust
The adjustments are pretty obvious on the the top of the transmission under the air intake and exhaust plumbing.
The adjustments are pretty obvious on the the top of the transmission under the air intake and exhaust plumbing.
The adjustments are pretty obvious on the the top of the transmission under the air intake and exhaust plumbing.
Thats fairly easy to do. First block the wheels so the vehicle will not roll. Put the transmission into neutral. Go under the car and on the drivers side of the transmission pan you will see the linkage. Remove the pin holding the linkage to the transmission. The linkage should slide in and out of the transmission shift bracket easily. If not loosen the nut on the linkage and adjust it until the linkage slides in and out without binding.
The 1993 Mercury manual transmission linkage will have adjustment nuts on each end of the linkage. Turning the adjustment nuts will move the linkage back in forth.
If this is an automatic transmission, the switch is located on the driver side of the transmission housing where the linkage plugs into the transmission. If it is a manual transmission the clutch safety switch is located near the top of the clutch pedal.
Depends on the transmission. Many transmission bands are not adjustable.
no adjustment on the 5speed manual transmission with overdrive. hydraulic clutch
usually a linkage problem - adjust linkage that connects transmission to gear shift
transmission is in but cant get linkage right. photo would help
Buy a Chilton's Manual for step-by-step instructions.