0
If you just want to add a little you can use the overflow tank to do it or if the radiator isn't full just take the radiator cap off and pour it in.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you add freon to Monte Carlo?
The Funny Side. I don't think the population of Monte Carlo would be very impressed if you sprayed them with freon.
Where is bleeder valve on 99 Monte Carlo?
Add gsdgc ggdd ff
How do you add transmission fluid to 1995 Monte Carlo?
pull the tranny dipstick out and add the fluid through the dipstick tube.
Were do you add oil in the 1984 Monte Carlo?
look for a oil cap that you take off on the valve cover.
Where do you add antifreeze on a 2003 Chrysler PT Cruiser?
You add to both the radiator cap and the overflow bottle.
Where do you add power steering fluid in a 2002 Monte Carlo?
in the top of the power steering reservoir on the passenger side of the engine.
How do you add power steering fluid to a 1986 Monte Carlo?
Remove cap to power steering reservoir, add fluid, place cap on reservoir when done.
Where do you hook up the hose to add freon to a 1995 Chevy Monte Carlo?
Quick release fitting located on the low pressure side (Larger hose from compressor)
1997 Monte Carlo how to add refrigerant?
Nah, It's easy. AnswerJust get a refill shop from the Auto parts store. The valve to refill is under the washer reservoir and just north of that
How do you add power steering fluid to a 2002 Monte Carlo ss?
Passenger side rear of engine down low. I had to take the two nuts off the strut tower tie bar and lift it slighty to get down there. That is a lousy design!! I then used a snorkel funnel to add fluid. On my 2001 Monte Carlo it is to the right of the bottom of the engine coolant, below and at the rear of the alternator, just in front of the fire wall. Hard to find unless you know where to look, good luck.
How do you add antifreeze to a 95 grand am?
you open the plastic bottle and pour in the antifreeze
How do you change antifreeze in a Honda civic 2003 1.7 ctdi?
When changing the antifreeze first drain the old fluid by disconnecting the lower radiator hose. Plug the hose in and add coolant to the radiator. Check for air in the system, bleed if necessary.
