0
Add your answer:
Earn +20 pts
How do you change the ignition switch in a 1988 Chevy Camaro?
How do i change the ignition switch in a 1988 Chevy camaro
1988 jeep wrangler runs while cranking quits when you let off?
you have an open circut in your ignition switch change your ignition switch.
How do you change or fix an ignition switch on a 1988 Corsica when the key turns but does not actuate anything?
If your 1988 Chevy Corsica key only turns in the ignition and does not start the automobile, it is probably unfixable. Remove the ignition switch retaining ring. Slide the out and remove the wiring harness. Reverse the process to install the new ignition switch.
How do you remove the ignition switch in a 1988 Isuzu pickup?
how to remove lock cyliner switch 1988 Isuzu pickup
How do you install key ingition switch 1988 Chevy S-10?
how do install key ignition switch 1988 Chevy s10
How do you repair the ignition system on a 1988 Jaguar xj6 that will not turn off the engine and does not kill power feed to dash?
sounds like u need to change the ignition switch itself ( the keybarrel)
How do you change the ignition control module in a 1988 Chevy Silverado 5.7 L?
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
How do you remove the ignition switch from a 1988 Dodge Ram 50?
Ignition switch and lock cylinder removal 1988 Dodge Ram 50.Disconnect the negative battery cable from the battery.Remove the steering column cover to gain access to the ignition switch/lock cylinder.Using wire cutters, remove the cable band.Remove the bolts that hold the ignition switch/lock cylinder to the steering column.Unbolt and remove the key reminder switch and remove the switch lock cylinder from the steering column.
How do you set the timeclock in a 1988 Chevolet Celebrity?
With the ignition switch on and the radio OFF, push the set button. Then use the Seek and Scan buttons to change the hours and minutes.
What does the wire on the ignition key switch of 1988 Mercury Sable belong to?
I believe that wire is for the key is in the ignition warning buzzer! Not 100%, but 90%.
Where is the ignition switch located on 1988 Monte Carlo?
The key and tumbler are on the side of the column. There is a rod that goes down the column to the ignition switch. It is accessed on top of the column and half way down.
Where is he ignition switch located on a 1988 Monte Carlo?
The key and tumbler are on the side of the column. There is a rod that goes down the column to the ignition switch. It is accessed on top of the column and half way down.
