How do you reset the oil life light on Mercury Mariner? Dealer didn;t reset at oil change & we are out of state now. Thanks
push in the info button on the dash a series of times until fuel life comes up and it will say reset fuel life then hold the button until it says reset it will then display fuel life 100 persent
You scroll thru menu until you see oil life and hold button in for 3 seconds and it will change it to 100 percent.
Turn the ignition to run (one position before starting engine). Press and release SETUP to display "OIL LIFE xxx% HOLD RESET = NEW". Press and hold RESET for 2 seconds and then release to reset oil life to 100%. Turn ignition off and then start engine to verify the indicator has been reset.
The GM Oil Life System calculates when to change your engine oil and filter based on vehicle use. Anytime your oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where you change your oil prior to a CHANGE OIL message being turned on, reset the system. Always reset the engine oil life to 100% after every oil change. It will not reset itself. To reset the CHANGE OIL message, do the following: 1. Press reset stem till it Displays "OIL LIFE" on the DIC.(3 times) 2. Press and hold the reset stem. The oil life will change to 100% and a beep will sound. 3. Turn the key to LOCK. If the CHANGE OIL message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure. Hope This Helps.
Turn ignition on,need not running.Hold the reset button in until oil life xxx% blinking ,let go the button.Then hold it in again until it shows oil life 100%.
You can reset the 2007 Avalon maintenance light by setting the oil life to 100 percent. When the oil life display is on your monitor, hold in the scroll button until it goes to 100 percent.
If your truck has the DIC (Driver information Center) Make sure the truck is in PARK. Change to the display "Oil Life Remaining" Press and hold the SET/RESET button on the DIC for 5 seconds. If you don't have the DIC the make sure the truck is in PARK and press the trip odometer reset stem for MORE THAN 5 SECONDS. The oil life will change to 100%.
2007-2010Turn the ignition to run (one position before starting engine).Display the OIL LIFE REMAINING on the DIC (i) button. If the vehicle does not have DIC buttons, the vehicle must be in P (Park) to access this display.Press and hold the SET/RESET (check mark) button on the DIC, or the trip odometer reset stem if the vehicle does not have DIC buttons for more than 5 seconds. The oil life will change to 100%.Turn the ignition off and then start the engine to verify the indicator has been reset
Change your oil/filter every 5,000 miles if you use conventional oil and every 8,000 miles if you use synthetic and you drive under normal conditions. If your vehicle is equipped with an oil life monitor system then change it when the system tells you too and reset the oil life monitor. If it does not come on for one year change the oil anyway and reset the system even though the light is not on.
press the setup button until it switches to life, then press reset, if the oil life is already up press reset first then press setup until it switches to oil life, then reset again
(This is quoted directly out of the Cadillac Service Manual Vol. 2)"After an oil change, the index may be reset by displaying the oil life index and then pressing the 'RESET' button for approximately 5 seconds. When the value is reset, 100 will be displayed for the Oil Life Index."