0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
what size bolt is used on idler pulley on a 4.3 2003 astro van?
Take the belt off, take the bolt off of the idler pulley, take the pulley off, put a new one on replace the bolt, and put the belt back on
How do you change the serpentine belt on 2003 Toyota Highlander?
Locate the idler pulley and release the tension. Remove old belt and replace it with the new one (there should be a sticker on the underside of the hood or on the radiator housing showing the path for the belt) and re-tighten the idler pulley.
How you change idler pulley on 2003 Nissan sentra 1.8?
The idler pulley on a 2003 Nissan Sentra 1.8 is changed by removing the engine accessories, removing the drive belts, and loosening the retaining bolt. The pulley can then be removed from the vehicle and a new one bolted into place.
How do you change a idler pulley on a 2003 Malibu?
First you would need to take the serpentine belt off of the engine, and then remove the bolt in the center of the idler pulley. I have included an instructional vieo of how this is done.
How do you find and replace an actuator for a 1999-2003 ford windstar lx climate control switch?
electric window binds on 2003 ford windstar
How do you loosen the tensioner pulley in a 1996 Tracker?
We recently replaced the serpentine belt on our 2003 Chevrolet Tracker. We were able to place a wrench (I believe it was 9/16") on the tensioner pulley and apply pressure so the pulley released tension on the belt. This however did no allow enough slack to install the new belt so we removed the idler pulley at the top center of the engine. With the idler pulley removed we were able to route the belt and with the tension released on the tensioner pulley, routed the belt under the idler pulley and reinstalled the idler pulley, then released the tensioner pulley and the belt was installed. Be sure to note the exact route of the old belt before removal so the new belt follows the same path. Hope this helps.
How do you loosen serpentine belt on 2003 Rav4?
The serpentine belt on a 2003 Toyota Rav4 can be loosened by turning the retaining bolt on the idler pulley. The belt can then be shifted inward to loosen.
How do you replace a serpentine belt in a 2003 Pontiac aztek?
First you need really small hands to get in between the fender well and the idler pulley. You need a 3/8 inch break over to get in and pull the idler over to relieve the belt tension. Then you can slip the belt off and put the new one on in reverse order.
How do you change the idler pulley in a 2003 Sedona?
According to Troy Dean Potensky's Auto Parts in Issaquah, Washington, you may have to see a professional for that if you know what I am saying ;)
How do you loosen the tension pulley on a 2003 ford Windstar?
Hard to tell if this question is to:Release the tension on the belt for replacement, orRemove the pulley/tensioner for replacementSee "Related Questions" below for more about doing both
How do you fix the window pulley on a 2003 Pontiac Grand Prix?
You will have to replace the regulator assembly.
Will a ax4s transmission from a 2000 Windstar fit in a 2003 Windstar to replace the ax4n?
Umm, short answer, no. Two completely different transmissions, controlled in two completely different ways.
