On the bottom of the heater/ac assembly in front of the passenger compartment . YOU KNOW BEHIND THE DASH .
It is in the center of the HVAC housing under the dash.
how to replace a blend door actuator on a 1999 ford ranger
It is in the center of the HVAC housing behind the dash.
To replace a blend door on a 1999 Voyager, you will begin by checking which side of the vehicle is not receiving heat. Then, remove the glove box door by squeezing the inside of the door toward the center of the door to access the blend door.
I believe you are looking for blend door actuator???
The blend door actuator can go bad. Big job to replace it. Dash assembly must be removed to gain access to it.
No.
The blend door actuator on late model Dodge Durango and small pickup can be accessed by removing the glove box. There is a very common problem with blend door failure in these vehicles, and dash removal is required to perform the repair. A cheap and easy DIY fix for this can also be found at heatertreater. They also make a heater core regulator which bypasses the blend door and can remedy the situation with no dash removal.
Bad "blend door" actuator or stuck blend door on the driver's side.
my 1999 winstar was doing this and it was the blend door
The blend air door is probably broken.