answersLogoWhite

0


Best Answer

buy the manual and follow it. Since you are asking on this fourm I'd say don't attempt it because, after all, the first step is to pull it out of the car.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How can you rebuild a 1994 Jeep YJ 4.0l inline 6?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the fuel filter on a 1995 Jeep Wrangler 40L?

Look under vehicle foolow the fuel line from the tank


How many cm3 are in 40L?

40L = 40000cm3


Where is the fuel filter on a 1997 Jeep Wrangler 40L?

It's part of the fuel pump assembly located inside the gas tank.


Would a gasoline tank hold about 40ml or 40L?

On a car, 40 liters.


The person name that killed Aaliyah?

The pilot-operator of the Cessna 40l which fatally crashed.


Is there an access door for a fuel pump on a 96 4 door 4x4 40L explorer?

No door. You have to drop the tank.


Engine removal procedure98 explorer 40L V6?

Get a Haynes or Chiltons manual from an auto parts store and don't forget to label everything.


Where can you find a vacuum hose schematic for 1995 40L AWD aerostar?

It is located underneath the hood. You might have to clean it off with a rag to read it.


What is the oil to petrol mix for a dt15 suzuki outboard?

My mechanic says 100:1 I have done this for 40l last season without a problem


How do you replace the serpentine belt on a 99 Jeep Wrangler 40L that does not have a belt tensioner?

The belt tensioner is located at the bottom of the power steering pump looking at it from the front the tensioner is on the bottom left. you could always loosen the alternator up a little. My 1997 with a 4.0 does not have a tensioner pulley, and I believe the 99s are the same. the alternator is the tensioner. Remove one of the bolts and it will swivel in and you can get the belt off


Can you fit a 50 mustang engine in a 1993 ford explorer xlt 2x4 40l v6?

i would deffinatly say yes since some of the year models came with a 5.0 stock.


Your 1993 wrangler 40L inline six will crank and rollover but will not start replaced distributor wires plugs starter ignition coil map sensor throtle position sensor fuel pressure good?

If it's not the crank sensor, it's probably the ECM, and that's bad. Try you crank shaft position sensor, if it is bad the engine will not run. It's on the back of the engine just below the vavle cover on the drivers side You can also try the ignition pickup. It's a little back plastic plate that sits on top of the distributor when you take the cap off.