Move the front seat forward and remove the bolt covers on rear of seat bottom, Remove the 2 torx head bolts, unplug connector, and push bottom upward and lift to unhook front track and lift out of car
Yes, but there must be some work done to the car. you must lift it a few inches with high springs and shocks. if you do not, there will be rubbing on the front wheels when you turn
Yes sir, with modifications to wheel well(cut) and lift about 3 inches!
Under the rear seat. Lift on the front of the rear seat and should pop out somewhat easily.
it is under the passenger set on the back, lift up through the front and it will slide right out....
they could fit but youwould have to modify the suspension a couple of inches of lift would be need . then they would fit . but it if you dont lift the suspension the tires will rub the wheel wells . !
A lift kit, you can look it up to see if they have it for your car, or you can retro fit a different one.
33" in the front and 35" in the back. I you tighten your torsion bars all the way in the front you can lift your front end 2.5 inches and fit 35's all the way around.
Its under the back seat. have to lift it up in the back and pull out towards the front of the car, your other fuse box is there as well.
you cam in the back you just gotta get something custom done to the front the strut plate is in they way
Drivers side, front, two Phillips screws, pry open towards passenger side , lift out like a piece of toast out of a toaster.
lifting a rodeoGo to www.calmini.com they have everything you need to lift it...They ain't cheap but its the only lift kit i found for mine...what you could also do is crank up your torsion bars in the front it will give you about 2 inchs in the front and get 2 inch lift shackles in the rear..its about 50 bucks for a 2 inch lift...If you wanna go biggr than 2 inches go to calmini.com