1. turn ignition to 'ON'. You don't need to start the engine. Wait for the three beeps to end.
2. press and hold 'UNLOCK' on a GOOD PROGRAMMED fob for at least 4 but not more than 10 seconds. (Alternatively you may have to hold the UNLOCK for 4 to 10 seconds and then simultaneously press the panic button for 1 sec and then release both)
3. press and release both the 'LOCK' and the 'UNLOCK' buttons on the fob you want to program simultaneously.
4. press and release any other button on the fob you want to program. A chime should sound in the Liberty confirming the programming.
5. ***This is important*** - it doesn't really spell this out in the owners manual but at this point your previously unprogrammed fob works - but - your previously programmed one WON'T! You now have to press both the 'LOCK' and 'UNLOCK' buttons on the previously programmed one and then press and release any other button and again you should hear the chime and then you will have two programmed fobs. Turn off the ignition
6. Neither will not immediately work. You have to wait about 1 minute or turn the ignition off and then on again. And both should work.
mine does
how do program 2005 Toyota Prado remote control
It has to be by a dealer.
I HAVE BEEN TO PROGRAM 2 REMOTE CONTROL FOR TOYOTA SIENNA 2002 BUT I CAN"T DO THAT. WHEN I ACTIVE 1 Y UNDER ONE NO ACTIVED
how can I set the remote control of the homelink garage opener in my Explorer Limited 2002 ?
disconnect the batt... for 5 to 10 min to reset
Fuel injector #3 control circuit malfunction.
replace the switch
the answer is no. 2002 was the first year the liberty was made. in 2003 they change the computer modules..the only engine you can put in a 2002 jeep liberty is a 2002 engine
I have Nissan Pathfinder 2002 Chilkoot...and Fuses are behind COIN BOX... DO you have Fuse Diagram... I am looking for remote lock/unlock
Sedurity code to WHAT? The radio? The remote door lock control?
The Remote Viewer was created in 2002.