Wiki User
∙ 8y agotherangerstation.com as well as autozone.com both have decent write ups for this problem.
Wiki User
∙ 8y agoThe answer is too involved to answer here. Buy a repair manual ($12) at most auto parts stores. There you will find detailed instructions.
No you don't have to drop the transmission in order to replace the slave cylinder, but be careful because it can easily be stripped.
It depends on where the slave cylinder is located. If it is inside the bell housing you will have to remove the transmission.
Your local Nissan dealership can give you detailed instructions regarding the replacement of your starter. The detailed instructions can also be obtained from most auto-parts stores.
To replace the slave cylinder on this vehicle you will have to remove the drive shaft and then the transmission. The slave cylinder will be bolted to the inside of the bellhousing. The transmission is very heavy so be very careful.
According to the manufacturers instructions.
how do i replace the maser cylinder on a 1995 GMC Sierra
We have detailed instructions on our enthusiasts forum at www.trailvoy.com
The transmission has to be removed to gain access to the clutch slave cylinder.
Remove the transmission to excess the inturnal slave cylinder
The transmission must be removed, and put back in, not replaced.
Yo have to remove the transmission.