answersLogoWhite

0


Best Answer

well if you have a code for the glow plug circuit then you may or may not have a glow plug issue. Could be wiring or relay or the controller. If all is ok glow plugs typically have 0.05-0.08 ohms of resistance when bench tested out of vehicle. Good luck hope this helps.

User Avatar

Wiki User

βˆ™ 12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How can i tellif a glow plug is bad?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1997 f 350 7.3 turbo diesel hard to start?

glow plug timer is bad or the glow plugs them selves are bad


How do you tell if glow plug relay in 2003 is bad?

It is important to know the signs of a bad car part.The signs that a glow plug relay would be fast clicking from the solenoid, or no clicking at all.?æ


What are symptoms of glow plug problem?

A glow plug problem can be spotted by the vehicle having trouble starting the engine. The indicator light in the for a glow plug can indicate a bad disconnected or corroded glow plug, or even a bad temperature sensor. If when you first start the engine there is a misfiring until the engine warms up, it is a good chance a glow plug problem. Usually misfiring will cease after the engine has been running about ten minutes. One of the last systems of a bad glow plug is you see white exhaust when starting the engine. Diesel is let into the combustion chamber to start the engine. A bad or even disconnected glow plug will allow diesel to leak from the chamber into the exhaust. The fuel is then ignited in the exhaust pipe and produces a white smoke. Once the engine again warms up the white smoke will stop.


Where are the glo plugs on a f250 6.0 powerstroke?

The glow-plugs are located under the valve covers. There is a single wire that comes out of each injector harness that powers each glow-plug. Disconnect the single wire from the glow plug. Connect the gator clip of a test light to a positive and probe the glow plug terminal with the test light. If test light does not come on the glow plug is bad.


Why does a common rail Isuzu diesel turn over but won't start?

bad glow plugs or faulty glow plug timer module


How do you test glow plugs in a ford transit?

You can test each glow plug while still installed in the engine. Just get a test light and connect it to the positive terminal of the battery and touch the point of the test light to each glow plug terminal. If the light lights up the glow plug is good if not it is bad. You can replace the one or more that are bad or replace them all since they may not be too far behind.


How do you install glow plug?

how to install glow plug on ford f350 l997


Why wont your diesel f350 start without being plugged in?

possibly the glow plug comand is bad.


Where is the location of a glow plug in an Isuzu wizard?

Where is it heater glow plug fuse isuzu


Where is glow plug relay on 89 f 250?

We're do I find glow plug relay


Where is the glow plug relay on a vw sharan?

where is the glow plug relay on a vw sharan 97


Where is the fuse for the glow plug relay in a 1988 Chev diesel surburban?

The glower relay itself and it's associated controller don't have fuses as such. Each glow plug has a fusible link (which is similar) but you wouldn't know to check this if the 'Wait to Start' or 'Glow Plug' light was lit as normal. Troubleshooting a bad glow controller is a little more complex and you need to verify that the plugs themselves are OK first.