If you bored a 350 0.080 over It would over heat / run HOT. There would be very little cylinder wall left. You can't even BUY 0.080 over pistions.
If you bored a 350 0.080 over It would over heat / run HOT. There would be very little cylinder wall left. You can't even BUY 0.080 over pistions.
Yes, Yamaha made an 80, a 200, and a 350 Big Wheel.
.80 mm then you need to replate it
80% of 350 = 80% * 350 = 0.8 * 350 = 280
350*80/100 = 280350/10*8 = 280
4.375
A 350 Chevy bored 80 over would be a 364 cubic inch V8. Here's a simple formula to figure the displacement of a V8 engine: Multiply bore X bore X stroke X 6.285 and you can figure out the displacement of any V8 engine based on what the bore and stroke is. Now, before you bore a block that far over, make sure the block can safely handle that much of an overbore. An extra 5 or 10 cubic inches isn't going to make enough of a difference to justify making the cylinder walls too thin.
(280/80)x100 = 28000/80 = 2800/8 =350%
350 + 80 + 35 = 465
Let's say that 350 is 100%10% = 3520% = 70Answer = 350 - 70 = 280 = 80%
280 as a percentage of 350 is 80%