You have to take off the wiper arm and then take the nut off of the post that the arm attaches to. On the inside of the van take the trim panel off of the tailgate,then you can get at the bolts that hold the wiper motor onto the tailgate.
Generally ,at the base of the arm is a small hinged catch that you can gently pry open. Once you do this ,the arm can be pulled off.
Remove the wiper arm retaining clip. The retaining clip will be just below the wiper arm connection. Hold the retaining clip in and the wiper arm will come off.
A wiper arm on a 2001 Honda Civic is screwed on. To remove it unscrew the mounting hardware and take off the wiper arm.
get a wiper removal tool and it goes under the arm and you just pry the arm up off the splines to take it off.
Assuming you mean wiper blade off the arm rather than removing the arm, see sources and related links below.
Not sure if the 95 and 99 Voyagers are the same, but on a '99 Voyager to remove the rear wiper arm, you have to lift a tab that is to the right of the circular cap. You have to raise the wiper arm off the glass then pry the little tab up. After the tab is raised, you can wiggle the arm off the wiper motor.
turn it off The rear wiper switch is on the end of the turn signal arm. Look at the picture on the arm to see where off is.
at the base of the wiper arm is plastic it looks metal but it isn't remove it with a flat head screw driver then use a 1/2" wrench or sockett to remove the nut and the arm will come off at the base of the wiper arm is plastic it looks metal but it isn't remove it with a flat head screw driver then use a 1/2" wrench or sockett to remove the nut and the arm will come off
on bottom of arm is a nut, to take off arm remove this nut, then wiggle arm off shaft.
how do get rear wiper arm off fiat punto grande
If one wants to replace a wiper linkage there are a few steps involved. Pull the wiper arm away from the windshield until the arm locks in vertical position. Unbolt the nut that holds the wiper arm to the linkage and pull the wiper arm off the linkage. Open the hood and unbolt the wiper motor and slide the motor off of the linkage. One then will remove the wiper linkage and install a new one.