There is not a front licensing mounting bracket, on a Chrysler Sebring. The Chrysler Sebring has a rear license plate mounting bracket.
Mounting a European license plate requires special items. A front end Euro front mounting plate needs to be acquired, as well as the brackets that go with it.
The mounting bolts for the license plate
With thh proper license plate bracket and screws.
remove the license plate and reach up through that opening. Corvettes weren't designed to be easy to work on.
Since your question does not indicate that the other "running" lights are not working, I suspect that they are working. Since the license plate light does NOT have it's own dedicated circuit, and therefore it's own fuse, it is not a blown fuse. IF all other rear lights, are working, then the problem is limited to the bulb SOCKET or the hot wire to it. That wire is relatively short, in that it is connected to the tail light wiring in the trunk area near one of the tail light assemblies. I can think of three possibilities that would cause the lcense plate lamp circuit to be "open:" 1. Somehow, the wire got cut or broken. 2. A connector has become disconnected. 3. Water has gotten into a connector, bulb socket, or ground connection, causing corrosion which impedes the flow of electrical current.
Must be visibly mounted at rear of motorcycle (so on a plate off of license plate is a pretty good spot).
Read license plates on any motorized vehicle need to be displayed in such a manner that the numbers/letters are easily read from certain distances, and common sense says that a horizontal mounting of the license plate would be what is required for your safety and the safety of others. For further information contact your local motor vehicle office.
might be broken wires look were the boot lid hinges
What kind of question is this? If you have a drivers license you can drive any vehicle other than semi n big things like that u need a CDL 4 that
There is a plate mounting bracket available from the Range Rover dealer. You can also have the dealer install it if you don't want to drill holes through your bumper.
No, in Texas motorcycle license plates must be horizontally mounted. Vertical mounting is not allowed as it does not comply with state regulations.
Use self-tapping screws. Before making holes with the screws ensure that the location is central and at the correct hight. Depending on the car, it may also be possibly to obtain a (very inexpensive) license plate and mounting hardware kit from a dealership.