I have a 1994 Rodeo, 4WD, 5 SPD, V-6 3.2 engine and I just replaced my flasher on August 2, 2007. Hopefully, your 1995 is the same! The hazard/turn signal flasher (#E34 black rectangular unit at AutoZone or Pep Boys) is mounted BEHIND the left front speaker. I removed the 4 or 5 screws that held the left side of my lower dash to the dashboard. Then, I removed my LEFT SIDE speaker (driver's side) and with a flashlight was able to see the black hazard/signal unit. The hardest part was actually getting my fingers in there to pull it out. My 1994 Rodeo still had the original unit which is held in place by two tiny locking nubs, one on top and one on the bottom. I finally ended up breaking one of the little nubs to remove the unit! (It DOES NOT MATTER since the replacement unit has no nubs and simply slides straight in.) You MUST be patient and careful since the location is a real challenge! By the way, the parts counter person told me I had separate flashers for the hazard and the turn-signal. WRONG! There is only one unit which controls both actions! (The catalog lists both an #E12 yellow round unit AND the #E34 black rectangular unit. The #E12 did NOT fit my vehicle!) Good luck!
The diagnostic port on a 1995 Isuzu Rodeo drive is located on the lower kick panel on the driver's side. It is just below the left spark plug.
where is the pcv valve located on a 1995 Isuzu rodeo v6 3.2l
Hello... what is the original size of the muffler that came with a 1995 Isuzu Rodeo lengh etc...
How do you adjust the valves on a 1995 isuzu Rodeo 3.2
On the left
www.tirerack.com
it takes 3.2L
Hi, How Do You Replace a Starter on a 1995 Isuzu Rodeo, V6, 3.2 liter engine? Does anyone know where the starter is? Help. How Do You Replace a Starter on a 1995 Isuzu Rodeo, automatic, 4wd, V6, 3.2 liter engine? Does anyone know where the starter is? Thanks alot.
it will fit but you will have to get new hoses for the correct sizes
It's 4500lbs
its on the drivers side kick panel
have your intake gaskets checked common with rodeo