0
* 11 No ignition reference signal detected during cranking (bad Hall effect) OR loss of camshaft sensor (and, for cars with crankshaft sensors - which does not include the 2.2/2.5 - timing belt skipped a tooth or loss of crankshaft sensor). See note #8 below.
Can cause the engine to stop working entirely with no limp-home mode. Note: An anonymous poster wrote, "Code 11 will only be set upon clearing the codes, most commonly by disconnecting the battery. It says in the factory diagnostic manuals that code 11 means no ignition reference signal has been seen since battery disconnect. As soon as the vehicle's engine is cranked, and a reference signal is seen, code 11 will go away immediately on it's own. It also won't be set upon failure of a part such as a hall-effect pick-up plate, or loss of the timing belt. If no reference signal is seen during cranking after a battery disconnect, code 11 will remain. This is a helpful indicator in a no-start condition." (Chrysler did sometimes change codes depending on the year, so it may be that some of these apply to differentyears.)
Add your answer:
Earn +20 pts
What type engine is in your 1996 Dodge van B2500 HAVE?
Chrysler 3.9, 5.2, or 5.9L
What liter size is a 6 cylinder engine in a 1996 Dodge Conversion Van B2500?
3.9l
What is the spark plug firing order for a 1996 Dodge Ram Van B2500 V6?
1-6-5-4-3-2, rotation clockwise
Where is the fuel filter located on a 1996 Dodge Ram B2500 Van 5.2 liter?
Your fuel filter is actually a "fuel sock" attached to the bottom of the in-tank fuel pump.
Where is the crank sensor located on a 1996 Dodge Ram van 3.9 b2500 and how do you install a new one?
The crank sensor is located on the bell housing of the transmission on passenger side. You will need an Allen wrench.
Is there a cabin filter in a 1996 B2500 van?
Didn't come with a cabin filter.
How do you find the size of drum brake on a 1996 dodge b2500 van?
Other than measuring it, any Auto Parts store has this information. The maximum wear diameter of the drum is cast onto the outside of the drum.
How do you replace floor pan of 1996 dodge b2500?
Since this vehicle is a unibody design, the damaged floor would have to be cut out and replaced with new panels. This would require considerable disassembly, and skill in this type of body repair.
How do you install a new radiator in a 1996 Dodge Ram Van B2500?
The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
Where is the wiper intermittent pulse board in a 1996 dodge b2500 van 3.9L?
we have a 94 and and a 97, same part but the 94 has it behind the radio and the 97 if i remember correctly is located behind the glove box insert, good luck
Will a 1996 dodge caravan take a 1996 dodge neon transmission?
No.
Why am i getting an error code p1698 for a 1996 dodge intrpid?
i read somewhere that it has to do with theTCM (trasmission control module) and your instrument panel might stop working.
