Looking for the ESC myself....the Knock Sensor wire is blue though.
Electronic Spark Control located near the brake booster.
code 43 is related to the spark control system. (esc) the problem is usually the knock sensor wiring connector is defective and/or the sensor. the sensor is located in the right /passenger side of the engine block near the starter.
thats your knock sensor ESC is Electronic Spark Control which governs timing.
Code 43 means Electronic spark control Check the voltage at the ecm a-b connector terminal B7 it should be over 6volts unless the system is sensing detonation.Check for a loose connection.Replace the ESC sensor and/or module
ESC / Electronic Spark Controll Circuit. and the knock sensor signal.
yes, when in video 1 mode use remote: Press (esc)(esc)7714(ok) that will take care of it. or (esc)(esc)7197(ok) a master reset is (esc)(esc)19750601(ok) window main screen (esc)(esc)9702(ok) hope this helps!
One needs to look at the module in the distributor (test it)and the ESC system (sensor, module, and harness connection). Replacing the whole ignition system is expensive and much more than swapping style of distributor.
ESC Lille was created in 1892.
ESC Bretagne Brest was created in 1962.
esc off light
Emeritus Corporation (ESC)had its IPO in 1995.