Wiki User
∙ 12y agoYes, the clutch throwout bearing is hydraulically operated.
Wiki User
∙ 12y agoIt has a hydraulic operated throw out bearing.
If it is a standard transmission S10 maybe they are talking about the "throwout bearing" which is part of the clutch operation that can go bad.
only adjustment is under dash on the master cly needs free play so it can return throwout bearing, under hood just open slave bleeder screw an close. if the don't cure it then clutch needs to be replaced.
I need to replace release bearing in a 1995 Chevy s10 truck and need to know how to disconnect the hydraulic clutch line for the transmission.
You have to pull the tranny. Might as well put a new clutch disc and pressure plate while you re in there as well.
It is a hydraulic operated clutch.
bad clutch, bad pressure plate, throw out bearing, air in the hydraulic lines...etc
you have to remove transmission to take out and replace throwout bearing
Hydraulic.
Bad throw-out bearing?
the clutch plate ,pressure plate and throwout bearing should cost around 110.00 labour will vary its about a 2 hour job for a garage or about 4 hours in your driveway
If the clutch system uses hydraulics, the flywheel should be shimmed the amount that was removed. Removing material from the flywheel moves the pressure plate away from the throwout bearing by the amount that was removed.