C1095 indicates a hydraulic pump motor circuit failure. First check to see that the 2-pin connector from the brake pressure control module is fully seated and has good terminal contact and no corrosion. If no, connect. If yes, check the pump motor. If the pump motor does not run, disconnect the 2-pin connector on the inside of brake control module, ground the brown wire and apply 12V to the red wire. Then again check to see if the pump motor runs. If it does not you will need to replace the anti-lock pump and motor assembly.
Here is a diagram.
I have a 1996 Mercury Grand Marquise. Where is the interior lighting switch on the door.
what year
red
EATC
Hopefully , yes ( if everything is working properly )
There is no adjustment or "calibration" for this.
go-cart Gremlin (a brand of car) Grand Marquise golf cart Grand Cherokee jeep
Fuel leak? Defective carbon canister?
Should be against the firewall towards the passenger side
Bad gasket, latch not fully holding trunk closed.
Leave it in o/d . The trans. will work just fine.