0
The IAC valve has two openings on the back of it. Spray throttle body cleaner or
brake cleaner spray into the holes and clean with q tips. There is a spring in
the middle interior of the IAC valve. It loosens up a little after being sprayed
and rubbed with q tips. You can access this area without opening the IAC valve.
We tried to open the IAC and had no luck. The screw in the bottom center of
the IAC is plastic and a torq bit tool is probably required.
We bought a used IAC off eBay for $70. It cleared our P1506 code : Idle air control overspeed error. But that code is back and I'm thinking it's the Front Left oxygen sensor since that sensor controls the fuel injectors and we have a lean isssue that I
am judging to be the cause for the RPM overspeed.
Just bought a new original equipment Denso oxygen sensor from www.densoproducts.com
One thing worth mentioning is we have a 1999 Mazda 626 V6 manual transmission
and I bought a throttle body with throttle position sensor and a IAC valve for a
2000 Mazda Millenia and they are interchangeable parts.
Add your answer:
Earn +20 pts
Where can you found a IAC valve gasket for a 1991 Mazda 626 DX?
Napaonline.com pick you vehicle on the left and browse the gasket section
Mazda 626 surges at idel?
check the Idle Air Control (IAC) may need to be cleaned. Refer to the following website. http://www.geocities.com/adamk01452/IAC_Clean.html
What is wrong when my 1993 Mazda 626 cuts off when i slow to a stop?
http://www.geocities.com/adamk01452/IAC_Clean.html this will refer to cleaning you IAC (Idle Air Control) valve.
Why 1993 Mazda 626 at low rpm stalls?
Your Idle Air Contol valve (IAC) may need to be cleaned. Refer to the following website for instructions http://www.geocities.com/adamk01452/IAC_Clean.html
How do i replace the iac valve for 2000 impala?
The IAC is located on the throttle body. Simply unplug the dirty IAC and clean or replace the IAC.
Where is the iac on 2000 Maxima?
The IAC valve is mounted on the upper intake plenum (manifold)
RPM goes up on your Mazda MVP?
iac is bad need to be replace
What could be reason for vibration in Mazda MPV in idling?
clogged iac valve
Where is the idle speed control actuator on a 2002 Mazda tribute?
I have a Mazda 2001 Tribute and I just replaced the Idle Air Control Valve (IAC). I searched for Idle Speed Control actuator and there does not appear to be one. The IAC is the silver module right on top of the manifold.
Where is the IAC Valve on a 1993 Mazda MX3?
The idle air control valve is on the the bottom of the throttle body.
Where is the Idle control valve on a 2000 Kia Sportage?
if you mean iac motor, it is located on the upper intake at the throttle body. if you mean iac motor, it is located on the upper intake at the throttle body.
What is engine check code P1507 on a 02 Mazda tribute?
Trouble code P1507 means: Idle air control (IAC) underspeed error
