0
Add your answer:
Earn +20 pts
1995 Chevy k15000 57L TBI no spark changeds ignition module coil cap rotor wires and plugs could it be a fautly module out of the box?
more apt to be the engine control module
How do you change the power steering pump on a 96 Chevy suburban with a 57l vortec?
need a puller to remove the power steering pump pulley, then remove the bolts holding the pump on
What do it take to put a 350 57L in a 2000 S-10 22L pickup?
Lots of time, patience, and money.
How many wire hookup is an alternator on a 95 57L 350?
not enough information what type of vehicle does it have a idiot light or gauge
Is 1 ton of topsoil more than 57L?
Topsoil varies in weight, depending on the type and texture, so it really depends.
My Prada sunglass lens is scratched willI Prada Luxotica have them refurbished if I send them to have this done?
prada spr 57l 1bc.1a1 120 3n
Is there a coil wire that goes to the optispark on a 95 Pontiac firebird with a 57L LT1 and where does it go?
The wire goes to the coil, which is bolted to the drivers side head in the front of the motor.
Where is the PVC valve located on a 2001 dodge ram 1500 57l?
should be in the top of the valve cover on the passenger side and i believe you mean pcv valve right?
Where are the timing marks located on a Chevy van g20 57l?
If this is a 305/350/400 small block Take the lead from the coil to the distributor "OFF" to prevent the engine from firing. This will take two people or a remote starter. Turn the engine over until the mark on the tortional damper lines up with the center or O mark on the timing tab on the front of the engine fastened to the crankcase front cover and the engine is in the number one firing position. This may be determined by placing fingers on the nuber one valve as the mark on the damper comes near the O mark on the crankshaft front cover.If the valves are not moving the engine is in the number one firing position.If the valves move as the mark comes up to the timing tab the engine is in number 6 position and should be rotated one more complete turn to bring it to the number one firing position. Also take the cover off of the distributor to determine that the rotor is positioned properly pointing to the number one spark plug then follow the firing order for that engine should be 1,8,4,3,6,5,7,2 Wayne
Can you put a 1991 350 57L in a 2000 S-10 truck?
Any thing is possible just depends on how much you want to spend and also where you live if you have state inspections then no if not then try S10v8.com or jagsthatrun.com
Where is the heater core found in a 1977 Chevrolet caprice classic 57L v8 is it on the firewall on motor side or in car dash?
The heater core is under the passenger side of the dashboard. I posted extensive directions on how to replace in another post under Chevys. vbd
How do you get the fan off of the water pump on a 96 Chevy van 57L?
You're probably finding that the shaft the collar nut is on spins when you try to remove it. There are several tricks. If the unit is still on - leaving the belt on for tension, heat the collar nut with a torch and rap your open end wrench with a hammer. this should loosen it rather easy. If the unit is apart, and your replacing the water pump, lock up the pump impellor, heat the collar nut and rap your open end wrench with a hammer. CAREFUL WITH THE TORCH. Good Luck.
