where is the purge soleniod on 1999 acura tl
also referred to as the Vapor Canister Purge Valve and is in\on the charcoal evaporator canister. its under the truck above the spare tire location, locate the charcoal canister on the front of the gas tank and trace the vent line to the vent valve.
You should be on the charcoal canister.
It is the small canister attached to the starter itself sometimes with a heat shield on it. The cables attach to the solenoid.
no you cat clean it sorry
above the rear end on the drivers side
In front of the right front wheel, accessible from under car only.
That 20 amp engine fuse number 1 feeds,all 4 O2 sensors,the mass air flow sensor,the EVAP canister purge valve solenoid,the EVAP canister vent valve solenoid,the crank sensor.Start with checking the codes (assuming the check engine light has been on). The codes may help lead you to the source.If there is no codes present, check each circuit listed above for damaged wiring.
check your charcoal canister, or evaporative purge system for a broken or missing vacuum line
The purge flow is a term used in the evaporation system....or the emmisions system. There is a puge valve that is solenoid controlled. The vapors purge into the intake while the car is running. if you get this code and your gas cap is tight. something is amiss with the fuel system tightness.
Can you use the abbreviation dr for door?"
The purge valve is on the intake passenger side of the throttle body. The vent solenoid should be on a cross member right behind the gas tank or somewhere in the general area (should have a red plug)