answersLogoWhite

0


Best Answer

ss

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you use starting fluid in throttle body?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Ran Chevy silverado out of gas won't start now?

is it carburated or throttle body injected? try putting a little gas in the carburetor or throttle body or if you have no gas try starting fluid but if you have gas in a jug use that because starting fluid is hard on the pistons and valves. and see if itll start


Where is the starting fluid sprayed in the 2000 Chrysler Town and Country that will help the van start?

The use of starting fluid is not recommended. Spray the throttle plate with just a quick squirt.


Have to spray starting fluid in the throttle body to start 1985 gmc jimmy S-15 any suggestions It is a v6 and has new fuel pump?

easiest and safest way to spray starter fluid is to spray it straight into air cleaner. you will not need to remove anything to do this and the engine will suk the fluid thru you really need to have the throttle body looked at ,as starter fluid is primarily for use in a diesel,not a gas engine


What is the use of a throttle?

A throttle is the system by which the flow of a fluid is managed by constriction. A throttle is used to monitor the position of the throttle in an internal combustion engine.


How do you start your diesel truck after changing the fuel filter?

you should try priming it by spraying starter fluid or gas or anything flammable enough to start the car into the throttle body then start it The use of starting fluid is not recommended by most engine manufacturers The priming method will vary from year to year, make to make.


Where does starter fluid go in a 1999 chrysler 300m?

The use of starting fluid should not be required, and is not recommended.The use of starting fluid should not be required, and is not recommended.


What are the signs that a throttle body is starting to fail?

Throttle bodys will make your car use more gas if it is starting to get carbon build up on it. This can be fixed by cleaning it out you do not need to replace the throttle body. Just take off the intake tube from it and look inside and turn the throttle so it will go horizontal in the chamber and look to see if it is black and dirty. If it is then go to any car parts store and buy a bottle of air intake cleaner and just spray it in the throttle body while the car is running and give it some gas so you can clean off the back side of the plate.


How do you fix a sticky carb on your 93 mark VIIIOne is sticking?

Spray the throttle body (carb) with cleaner, not carb cleaner. You should use throttle body cleaner because there is a coating on the throttle body that will be removed if you use carb cleaner and that coating that comes from the factory should not be removed.


1998 Nissan maxima throttle position sensor. When starting to drive the gas pedal gets stuck and have to apply pressure before it clicks to move. Is the TPS sensor the cause of it?

Probably not. Look inside the throttle body and see if there is a dirty buildup right where the butterfly valve rests when closed. Use throttle body cleaner to remove the buildup and it should work smoothly again.


Where is the throttle position sensor on a 2001 Isuzu rodeo?

THERE IS ONE ON THE GAS PEDAL AND ONE IN THE THROTTLE BODY. THIS VEHICLE DOES NOT USE A THROTTLE CABLE, IT HAS WHAT IS CALLED " FLY BY WIRE " .


How do you fix a sticking throttle in a Toyota Camry?

Use throttle body carbon cleaner, you can find it in any auto part store.


What causes trailblazer to go dead when idles?

If it goes dead when under load like a/c kicks on, then it's highly likey that you need to clean the throttle body. The throttle body is simple to remove. Use throttle body cleaner and clean the back and all ports. Always disconnect the batter before removing throttle body, it will mess up electronic memory if you don't.