== == Yes you can... BUT - Why would you...??? The oil adapter plate that has the feed hoses connected to it, is mounted where common oil filter plates are installed... The reason for the re-located adapter is to provide easier access to the oil filter for changes... The adapter plate has (2)-bolts holding it in place near the rear of the block... If you do change this out - Make SURE - that there are NO OIL LEAKS coming from the oil filter plate-to-block area...
The engine block coolant drain plug on 4.3 liter Chevy Blazer is located on the bottom of the engine, near the oil filter. It allows coolant to be completely drained from the block during maintenance.
The oil pressure switch on a 1998 Chevy Blazer is on the side of the engine block. It is located above the oil filter.
On the engine block. where on engine block?
In General the Oil filter is on the left or right side of the engine. If you have the 5.7L V8 then it should be on the drivers side, back where the tranmission and block meet.
in the middle of the engine block under the whatchamacallit in the middle of the engine block under the whatchamacallit
Inside the bottom of the engine block.
yes
Yes it has an oil filter. You will find it on the engine block somewhere.
DONT EVEN TRY IT THE HEADS ARE DIFFERANT BUT THE BLOCK IS BASSICALLY THE SAME BUT ITS NOT WORT THE HASSEL DONT EVEN TRY IT THE HEADS ARE DIFFERANT BUT THE BLOCK IS BASSICALLY THE SAME BUT ITS NOT WORT THE HASSEL
If the blazer had a v8 in it No if it had a 2.8 or a 4 cylinder Yes if it had a 4.3 engine.
Nothing at all. A long block is the complete engine. A short block is just the engine with no intake, exhaust, or accessories installed.
under the pickup in the center of the engine block