Lower intake manifold bolt 115 in/lb. Upper intake manifold bolt 18 ft/.
The 1999 Pontiac cylinder head gasket bolt torque specification is 160 pounds. The intake manifold bolt torque specification is 90 pounds.
Fox Lake Racing P-51 Intake Manifold mounting bolt torque spec. is ( 18 lb-ft ) 25 Nm
Torque is 30 Lbs at he intake bolts.torque bolt order is as follows:the numbers below also represent the bolt position on the intake.1 and 2 being the bolts in the center of the intake.6---85---71---24---311---912---10Hope that helps
For the upper intake manifold bolt on a 1999 Pontiac Grand Am, apply 25 N·m 18 lb. ft toque. It is best to have a reputable repair manual on hand to double check your specs.
1996 chevy c1500 pick up 305 motor bolt torque spec intake manifold
It is in a shlp manual from AUTOBOOKSONLINE.COM
The 1997 Buick LeSabre intake manifold bolt torque specifications is 45 pounds per square inch. The manifold bolts should be torqued in 15 pound intervals.
That's easy you can find those in the [http://www.themotorbookstore.com/chevpic.html Repair Manaul You Have].
350 ft/pds This above answer it laughable and you will break every single bolt if you try to torque them to that figures. The correct torque on cast iron heads is 30 ft/lbs.
torque for 97 taurus head
I FOUND THIS AT WWW.AUTOZONE.COM, CLICK ON VEHICLE SPECS . For your 1999 CHEVROLET TRUCK BLAZER 2WD: INTAKE BOLT TORQUE FOOT POUNDS (FINAL TORQUE) TORQUE LOWER MANIFOLD BOLTS TO 27 IN/LBS TORQUE LOWER BOLTS TO 9 FT/LBS TORQUE LOWER BOLTS TO 11 FT/LBS TORQUE UPPER MANIFOLD BOLTS TO 44 IN/LBS TORQUE UPPER MANIFOLD BOLTS TO 7 FT/LBS (TO TORQUE BOLTS & NUTS, START IN CENTER USING CRISSCROSS PATTERN)