http://www.wjjeeps.com/lamps/headlamps.htm
This page deals with headlights. The parent site has info about everything Jeep GC. Good luck !!
with a small punch and hammer
how do you adjust head ligths up or down on a 2001 Isuzu rodeo
There are four adjustment screws under the rim that can be tightened or loosened for adjustments of the headlights on 2000 Ford Escort ZX2
The headlights on a 2000 Kia Sportage are adjusted by turning the two adjustment screws on the side and back of the headlights. They allow for both horizontal and vertical movement.
It requires a star tool. There are two adjustments per light. Vertical and horizontal.
To adjust a 2000 Toyota Celica headlight prop the hood open. Located the headlight adjustment screws and tight or loosen to fit the appropriate height settings for maximum visibility.
I like to get on a dark road and adjust them with the screws on top and sides of the lights but don't blind the driver comming at you.
If you can get a hold of an owners manual it gives a good description of how to adjust the headlights. Mine is a 2000 and the manual is pretty detailed. The problem I have is the adjustment screws are broken off, have not figured out how to fix that.
Hi, if you look in the owners manuel under the headlights area it will show you the very easy way to adjust your headlights. Briefly, you have to remove the black shroud in the front of and atop the radiator are first. Then if you look down at the top of the headlights you will notice adjusting screws that require Philips screw driver to turn. This will adjust the lights up and down. Do at dusk and mark a point in the light being reflected on a wall and you can determine which way you are adjusting the beam. This should be done on a fairly level surface.
There is a screw (phillips) located next to the lo-beam housing, to the left or the right depending on which side you're going to adjust. Turn to the left and the beam will pitch upwards and to the right it will pitch downwards. Have fun ;D.
This is how to adjust a 2000 Dodge Neon's headlights. I think it will be similar to the 1996 model. Use a Torx (or star) wrench, like an Allen Wrench but with a star shaped head. To adjust the height, there is an oval slot in the metal frame above the headlight. Shine a light down and locate the torx head screw. Winding this screw will adjust the height. To know what height to adjust them to, park on a flat surface next to a wall. Turn the headlights on to high beam and mark the centre of the beam on the wall. Electrical insulation tape is good for this. Then roll the car back 10 feet and put the brake back on. Now adjust the headlights to point at the mark you just made on the wall. Usually you need to point them about half an inch lower when 10 feet back. There are similar torx screws that adjust the sideways direction of the lights. They are a few inches to the side and below the vertical adjustment screws. Good Luck. -Phil
no because 2000-2002 they used bigger headlights than the 95-99.