The anti theft system has been triggered. I would call your local Chevy dealership and ask them how to reset it.
its vary simple place your ignition key in the ignition turn the key to run wait 10 minutes for the security light to stop flashing it will be on steady do not turn the key off
with the security light on steady turn the key to start the car will start and run let it run
for 3 minutes
if this failes the resistor attached to the ignition switch has failed .
go to a auto recycler and get a replacement ignition switch with a key
install the resitor on your switch and repeat intsructions above
It means it might need coolant, if not than you should probably see a mechanic.
replace ur BCM (body control module)... mine did the same thing
Throwing a dart in the dark but what I found out the hard way is the Body Control Module is bad. Not bad to put in and a computer cant figure out if it is good or bad. If your security light goes off later then most likely.
first u need a big screw driver to break the steering column then u need to look down into the barrel right in front of u and wait for the bright flash
you probably have a wire touching metal somewhere or a short.......... you probably have a wire touching metal somewhere or a short..........
When alternative bypass security is enabled then flash should be done on a K750I otherwise it is unsafe to do a flash on the device.
A Relay [LOL]
Flash is not fully backward compatible, as some older Flash content may not be supported by newer versions of browsers or devices due to security concerns and the decline in usage of Flash technology. Adobe has officially ended support for Flash Player and encourages users to uninstall it from their devices to mitigate security risks.
Passlock not working properly.
The Security device manager is stored in the Router's Flash Memory
You can try to turn the key left and then turn back to right for disable the alarm
All versions of Adobe Flash Encoders are designed to recode Flash clips as other formats, based on the security settings and permissions on the file you are attempting to recode.