If the engine is running smoothly befor this, then read on...
This is a very common problem. You have a faulty TCC solenoid. I have replaced this sensor with very simple tools (a 10 mm socket, a rachet, a gasket scraper, a T15 or T20 Torx driver, and replacement parts). It took me about 1 hour to complete having never done this job befor. The following link will tell you how to replace the sensor if you have a 125C tranny (3 speed). Althou the car pictured is a fiero, the same procedure applies. http://www.kichline.com/chuck/fiero/TCC.htm Good luck!!
have a pontiac 6000 2.5 motor and it wont stay running
On the distributor.
The oil filter on a 1990 Pontiac 6000 is located on the driver's side of the engine compartment. It is on the side of the motor all the way to the rear, near the firewall.
Fuel tank
.060"
You could call your local auto parts store and they should know the answer to that one
There appears to be a large amount of information available for the Pontiac 6000 car. If one is wanting to view reviews these can be found on the Edmunds site as well as on Car Guru.
2.5L 4cyl base. Iron Duke
Wiring diagram of what component?
Should be at the bottom or rear of radiator
The weight of the Pontiac 6000 SE is recorded as being 3,021 pounds. This weight can be altered by aftermarket products which are installed on the vehicle or parts which may have been taken off of the vehicle since being manufactured.
its called a burnout