0
Add your answer:
Earn +20 pts
How do you remove 327 harmonic balancer?
With a balancer puller tool. With a balancer puller tool.
How do you install a harmonic balancer correctly on a 1967 Chevrolet 327 where there is no hole in the crank to use a tool?
assuming the crank is out,cool it in the freezer and warm the balancer ,the balancer should slip on. be careful ! I have not done this with a crank and balancer,but it works well in other applications. ie.sleeves in blocks.
How do you tell the difference between a 350 and 327?
Look at your harmonic balancer the 1 on the 350 is bigger than the 1 on the 327.
Are the harmonic balancers from a Chevy 350 and 327 the same size?
usually
Why is there no bolt on the counter balancer on your small block Chevy?
The 265, 283, and early 327's, did not have one. EVERYTHING after 69 had one. I have heard of them comming out, but, not usually without catastrophic damage to the radiator. Who ever assembled it, could have forgotten to put it in, as the harmonic balancer, presses on pretty tight.
What is the timing for a 1967 Chevy impala sports coupe?
4 degrees btc-before top dead center with the vacuum spark line disconnected.the timing mark location is on the harmonic balancer. this is for a 327 engine
What size carburetor was on the 1969 Chevrolet Impala SS 327?
It came with a Rochester 4 barrell Quadrajet.
How do you set points on a 327 Chevrolet engine?
how do i set a 327 9 degrees back
Plug wire diagram for electronic ignition Chevy 327?
The Chevrolet 327 plug wire diagram can be obtained from most Chevrolet dealerships. The diagram can also be found in Chevrolet service manuals.
What are the engine torque specs for 1995 Chevrolet Z28 327 engine?
First of all the 1995 Z28 had a 350 (LT1) not a 327(the 327 stamp on your engine block has nothing to do with the size). The specs for the '95 Z28 350 are: 275hp and 325 lb-ft
Is a 327 engine from a 1957 Chevrolet Bel Air a 6-cylinder?
No a 327 is a V-8
What is the point gap for a 1967 327 engine?
non existent.327 is a Chevrolet engineBut in a 1967 327 on a Chevrolet the Point gap is 19 thousands. Dwell angle is 28 to 32. Idle 700 RPM's
