Disconnect battery for about 5 minutes. Then connect it back. Should reset radio.
but should it show temp aswell and if some one opens a door or what radio channel your on
To replace a broken radio antenna on a 2004 GMC Envoy you need to unscrew the old antenna. Next, place the new antenna in the hole and screw into place.
2004 GMC Envoy is on page 28 http://documents.victorytechnologies.com//documents/product/929.pdf 2004 GMC Envoy is on page 28 http://documents.victorytechnologies.com//documents/product/929.pdf
It's in the fuse box and should be marked radio and the fuse box is up under the dash on the drivers side.
The radio should go off on it's own after a few minutes or when the passenger door is opened.
my 2008 Chevy Colorado radio stays on when you take the key out ,but turns off automatically when you open the door Yes it should stay on until someone opens a vehicle door
Behind the panel on the right hand side in the cargo area.
Probably the body computer is not shutting down. Ck drivers door switch for problem. Radio should shut off when any door is opened with key off.
Some 2005 Envoys came with a radio that was capable of receiving satellite radio without any other hookups. It was an option choice. A Sirius Satellite radio can be plugged into the radio, but it has to be a radio that is mounted on the dash, therefore a mounting kit is necessary.
all stores should have the same time...i know of some that dont even open but if they do open then they will be open by 12:00
Go to www.trailvoy.com Join the forum and get realtime answers or look for the "how to" articles in the articles section. They have complete instructions with pictures to guide the way. Say that BlazerNut sent ya! If the set up is the same as in a 2003 Envoy with the vents directly above the radio, that panel is one piece and should come off by grabbing the top of both vent holes with hands and pulling the panel towards you away from dash. Once panel is off, disconnect wires any wires and panel should completely be removed. Unscrew bolts by factory radio and pull out unit and unplug wiring harness.