bad clutch bearing
Connect your Freon bottle to the low pressure port on your 1998 Chevy S 10 Blazer air conditioning compressor. Discharge the Freon into the compressor. A recharge kit will make this process quite simple.
This has a vaccum operated servo; you probably have a vaccum line that has come off to the transfer case.
The collectr and all applicable o rings
There is no Air Compressor on a 1988 Chevy S-10 Blazer. I'm sure they meant the A/C compressor. And if you're not licensed to handle refrigerant you should take it to a mechanic that is since the lines will have to be disconnected to remove the old one and install a new one. Not to mention putting it under vacuum and recharging the system. The compressor is about $150 at Auto Zone, but removal and replacement rates vary.
Yes, the doors from a 98 Chevy Blazer will fit a 2001 Chevy Blazer with a little moderation.
It would all depend on the condition of the vehicle as with all vehicles
there are many things that could potentially be wrong with your case. can u engage your 4wheel?
1997 s10 4.3 Chevy blazer. what inlet does the freon go in. the one on the aluminum tank where the hose from the compressor goes into it?
Put it on jack stand. If the four wheel does not engage pull the cord on it and see if you can engage it manualy. If that works the actuater is bad and not pulling the cord.
The Owners Manual sez to be in Neutral when changing from one mode to the other.
Yes.